Filter
Top Products
MSP50C6xx Development Tools Guidelines
5-10
Note:
There is a three-way switch at the edge of the SPEECH-EVM board. After
you apply power to the SPEECH-EVM, you have to turn on the SPEECH-
EVM. There are two ways to turn on the board depending on the power
sources:
If you are using the on board with AAA batteries as the power source,
you have to slide the switch to the BATT position to turn on the board.
If the power is provided externally from TB1 connector, you have to slide
the switch to the EXT position to turn on the board.
Step 8: Open EMU50C6xx software. The yellow light on the scanport
interface should be ON.
Figure 5–2. Hardware Tools Setup
MSP Scanport
Interface
(MSPSCANPORTI/F)
RED
LED
GREEN
LED
YELLOW
LED
MSP50P614
Target development
board
IEEE1284
Parallel
Port Cable
PC Parallel port
18 V DC Target board power
Target
board
connector
LED DESCRIPTION
Red MSPSCANPORTI/F power
Yellow Emulation mode/programming (Emul/Prog)
Green Target board power