K-51
User Guide for Cisco Security Manager 3.2
OL-16066-01
Appendix K Router Platform User Interface Reference
SHDSL Policy Page
Line Mode The line mode used by the controller:
• auto—The controller operates in the same mode as the other line
termination (2-wire line 0, 2-wire line 1, or 4-wire enhanced). This is the
default for CPE line termination.
• 2-wire—The controller operates in two-wire mode. This is the default
for CO line termination.
• 4-wire—The controller operates in four-wire mode.
Note You can select Auto only when you configure the controller as the
CPE.
Line Applies only when the Line Mode is defined as 2-wire.
The pair of wires to use:
• line-zero—RJ-11 pin 1 and pin 2. This is the default for CO line
termination.
• line-one—RJ-11 pin 3 and pin 4.
Exchange Handshake Applies only when the Line Mode is defined as 4-wire.
The type of handshake mode to use:
• [blank]—The handshake mode is not specified. (When deployed, the
enhanced option is used.) This is the default.
• enhanced—Exchanges handshake status on both wire pairs.
• standard—Exchanges handshake status on the master wire pair only.
Table K-22 SHDSL Dialog Box (Continued)