Filter
Top Products
Default Color
Purpose:
To specify the color mode to Color or Black. This setting is used for a print job which does not specify a print mode.
Va lue s :
Color
*
Prints in the color mode.
Black Prints in the black and white mode.
Network
Use the Network menu to change the printer settings affecting jobs sent to the printer through the wired or
wireless network.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Ethernet
Purpose:
To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the
printer is turned off and then on again.
Va lue s :
Auto
*
Detects the Ethernet settings automatically.
10BASE- T Half Uses 10BASE-T Half-duplex.
10BASE- T Full Uses 10BASE-T Full-duplex.
100BASE- TX Half Uses 100BASE-TX Half-duplex.
100BASE- TX Full Uses 100BASE-TX Full-duplex.
1000BASE- T Full Uses 1000BASE-T Full-duplex.
Wireless Status
NOTE: Wireless Status feature is available only when the printer is connected using the wireless network.
Purpose:
To confirm the wireless communication status.
Va lue s :
Connection (Good)
(Acceptable)
(Low)
(No Reception)
SSID Displays the name that identifies the wireless network.
Enc. Displays the encryption type.
Wireless Setup
NOTE: Wireless Setup is available only when the printer is connected using the wireless network.
Purpose:
To configure the wireless network interface.
Understanding the Printer Menus 197