Filter
Top Products
*1
HTTP-SSL/TLS feature is available only when a digital certificate is set from the Dell Printer Configuration Web Tool.
IP Filter
NOTE: IP Filter feature is available only for LPD or Port9100.
Purpose:
To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP
addresses. The change becomes effective after the printer is turned off and then on again.
Va lue s :
No. n / IP Address (n is 1–5.) Sets the IP address for Filter
n
.
No. n / Mask (n is 1–5.) Sets the address mask for Filter
n
.
No. n / Mode (n is 1–5.) Off
*
Disables the IP Filter feature for Filter
n
.
Accept Accepts an access from the specified IP address.
Reject Rejects an access from the specified IP address.
IEEE 802.1x
NOTE: IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is available only when the IEEE
802.1x authentication is enabled.
Purpose:
To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on
again.
Reset LAN
Purpose:
To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting
the printer, all wired network settings are reset to their default values.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for a parallel interface, you can configure the Adobe Protocol
settings for the wired network. The change becomes effective after the printer is turned off and then on again.
Va lue s :
Auto Used when auto-detecting the PostScript communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP
*
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
Binary Used when no special processing is required for data.
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
USB Port
NOTE: USB Port feature is available only for the USB port on the rear of the printer.
Understanding the Printer Menus
201