Filter
Top Products
Understanding the Printer Menus
151
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
USB Port
Purpose:
To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on
again.
Va lues:
PS Data Format
Purpose:
To specify PostScript 3 Compatible communication protocol, you can configure the PS Data Format settings.
The change becomes effective after the printer is turned off and then on again.
Va lues:
Job Time-out
Purpose:
To specify the amount of time the printer waits for data to arrive from the computer. The print job is canceled if the time-out
time is exceeded.
Va lues:
System Settings
Use System Settings to configure the power saving mode, warning tones, time-out duration, display language,
and job log auto print settings.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
TBCP
*
Used when the communication protocol supports both ASCII and binary data to switch between them
according to the specified control code.
Binary Used when no special processing is required for data.
Disable Disables the USB interface.
Enable
*
Enables the USB interface.
Auto Used when auto-detecting the PostScript 3 Compatible communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP
*
Used when the communication protocol supports both ASCII and binary data to switch
between them according to the specified control code.
Binary Used when no special processing is required for data.
Off Disables the job time-out.
On
*
30 seconds
*
Sets the time the printer waits for data to arrive from the computer.
Available Range:
5–300 seconds