Filter
Top Products
Chapter 7 Servo Parameters|ASDA-AB Series
Revision January 2009 7-17
Communication
Control
Mode
Parameter Name Function Default Unit
Pt Pr S T
Related
Section of
User
Manual
P3-00 ADR Communication Address Setting 1 N/A
{ { { {
8.2
P3-01 BRT Transmission Speed 1 bps
{ { { {
8.2
P3-02 PTL Communication Protocol 0 N/A
{ { { {
8.2
P3-03 FLT Transmission Fault Treatment 0 N/A
{ { { {
8.2
P3-04 CWD Communication Time Out Detection 0 sec
{ { { {
8.2
P3-05 CMM Communication Selection 0 N/A
{ { { {
8.2
P3-06■
SDI
Digital Input Communication
Function
0 N/A
{ { { {
8.2
P3-07 CDT
Communication Response Delay
Time
0
0.5ms
{ { { {
---
Explanation of symbols (marked after parameter)
(★) Read-only register.
(▲) Parameter cannot be set when Servo On (when the servo drive is enabled).
(●) Parameter is effective only after the servo drive is restarted (after switching power off and on).
(■) Parameter setting values are not retained when power is off.