Filter
Top Products
Chapter 3 Connections and Wiring|ASDA-AB Series
3-26 Revision January 2009
3.3.3 User-defined DI and DO signals
If the default DI and DO signals could not be able to fulfill users’ requirements, there are still user-
defined DI and DO signals. The setting method is easy and they are all defined via parameters. The
user-defined DI and DO signals are defined via parameters P2-10 to P2-17 and P2-18 to P2-22.
Please refer to the following Table 3.I for the settings.
Table 3.I User-defined DI and DO signals
Signal Name Pin No. Parameter Signal Name Pin No. Parameter
DI1- 9 P2-10 DO1+ 7
DI2- 10 P2-11 DO1- 6
P2-18
DI3- 34 P2-12 DO2+ 5
DI4- 8 P2-13 DO2- 4
P2-19
DI5- 33 P2-14 DO3+ 3
DI6- 32 P2-15 DO3- 2
P2-20
DI7- 31 P2-16 DO4+ 1
DI
DI8- 30 P2-17 DO4- 26
P2-21
DO5+ 28
DO
DO5- 27
P2-22
3.3.4 Wiring Diagrams of I/O Signals (CN1)
The valid voltage range of analog input command in speed and torque mode is -10V ~+10V. The
command value can be set via relevant parameters.
C1: Speed / Torque analog signal input C2: Analog monitor output (MON1, MON2)