Filter
Top Products
CHAPTER 6 PCI Express card Hot Maintenance in Windows
6.3 NIC Hot Plugging
135
C122-E175-01EN
This section describes the hot plugging procedure for a NIC incorporated into teaming.
Note
- Be sure to perform hot plugging after removing the card. If the card is not removed, the operating system
may stop.
- There are some precautions on teaming with Intel PROSet(R). For details on the precautions, see ‘G.8
NIC (Network Interface Card)’.
1. Confirm physical location, segment number and bus number of NIC to be replaced.
Confirm the physical location, segment number and bus number with step 1 at ‘6.2.1 Replacement
procedure’ in ‘6.2 Common Hot Plugging Procedure for PCI Express cards’.
Note
In case of multi-function card, there are some cards that have same segment number, same bus number,
and different function numbers.
In this case, please perform Step.2 to Step.7 of follows respectively.
2. Confirm target NIC in Device Manager.
Confirm NIC with step 2-a at ‘6.2.1 Replacement procedure’ in ‘6.2 Common Hot Plugging Procedure for
PCI Express cards’.
3. Select the interface in Device Manager, and open Properties.
4. Click the [Teaming] tab, uncheck the [Team this adapter with other adapters] check box, and click the
[OK] button.