Filter
Top Products
Appendix A Screen Details
> A.34 Set IP Address for REMCS Port
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
799
Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
• Service Settings
- Service Settings
Specify the following service information for the REMCS port.
Enable the service information in the [Service Settings] for ETERNUS DX400/DX8000
series to receive and execute the request (*1).
• HTTP Port No.
Enter the HTTP port number in numerals 1 – 65535 (However, "23", "443", "1999", and
"1372" have already been used for the ETERNUS DX400/DX8000 series, and cannot
be specified for this field).
The default value is 80.
• HTTP
Select HTTP port "Enable" or "Disable" with the radio button.
The default setting is "Enable".
• HTTPS
Select HTTPS port "Enable" or "Disable" with the radio button.
The default setting is "Enable".
• ping
Select ping "Enable" or "Disable" with the radio button.
The default setting is "Enable".
• Maintenance Port
Select Maintenance Port (*2) "Enable" or "Disable" with the radio button.
The default setting is "Enable".
• Maintenance Secure Port
Select Maintenance Secure Port (*3) "Enable" or "Disable" with the radio button.
The default setting is "Disable".
*1: When user connects ETERNUSmgr or PC and the ETERNUS DX400/DX8000 series to check the
device status and perform maintenance, [Enable] the HTTP port or HTTPS port according to the
specification method of the IP Address (http or https). When the ETERNUS DX400/DX8000 series
receives ping, [Enable] the ping port. When user connects Storage Foundation Software ETERNUS
SF (such as ETERNUS SF Storage Cruiser) to check the device status and perform maintenance,
[Enable] the Maintenance Port or Maintenance Secure Port.
When using the [Set Remote Support] function or exporting operation log (Syslog function) to send
error information or operation event to the REMCS Center or Syslog server, or sending ping from the
device, the port for the Service Settings is not used.
*2: The Maintenance Port is used by Storage Foundation Software ETERNUS SF, such as ETERNUS SF
Storage Cruiser, to interface with ETERNUS DX400/DX8000 series. If Storage Foundation Software
ETERNUS SF is not used, select [Disable] for the "Maintenance Port".
*3: The Maintenance Secure Port is used by Storage Foundation Software ETERNUS SF, such as
ETERNUS SF Storage Cruiser, to interface with ETERNUS DX400/DX8000 series. This port sends
and receives the encrypted communication data. If Storage Foundation Software ETERNUS SF is not
used, select [Disable] for the "Maintenance Secure Port".