Filter
Top Products
ENWW Paper feed units of Trays 2 and 3 173
MFP disassembly/assembly
Paper feed units of Trays 2
and 3
Removing and reinstalling the
paper feed unit
CAUTION Be sure the power cord has
been unplugged from the
wall outlet.
Procedure
1 Pull out paper feed Tray 2 or 3.
2 Loosen the securing shaft screw, and
remove one screw.
3 Disconnect the inline connector (CN814,
834) and remove the paper feed unit by
lifting.
4 Reinstall the above parts following the
removal steps in reverse.
Removing and reinstalling the
paper feed Trays 2 and 3
WARNING! When removing the tray,
stand in a proper position
so that you do not hurt your
back and waist. If the tray
contains paper, remove all
paper before removing the
tray.
CAUTION Be sure the power cord has
been unplugged from the
wall outlet.
Procedure
1 Pull out paper feed Tray 2 or 3.
2 Remove the paper feed unit.
3 Remove four screws and remove Tray 2 or
3 by lifting.
4 Reinstall the above parts following the
removal steps in reverse.
Relay connector (CN854)
Securing shaft screw
Paper feed unit
Screw
Tray 1,2
Screws