Filter
Top Products
ENWW Fuser 211
MFP disassembly/assembly
4 Remove the front lamp harness from the
harness guide to remove the two Faston
terminals.
CAUTION When removing the Faston
terminals, be sure to hold
the connector. The
connector cannot be
removed by pulling on the
harness.
5 Open the fuser (top).
6 Remove the screw at the far side to
remove the lamp fusing plate (rear).
7 Remove the two Faston terminals of the
far side lamp.
CAUTION When removing the Faston
terminals, be sure to hold
the connector. The
connector cannot be
removed by pulling on the
harness.
8 Pull out the fusing heater lamps (L2, L3)
from the front side of the fusing upper
roller.
Faston terminals
(2)
Screw
Harness guide
Lamp fixing plate
(front)
Faston terminals (2)
Screw
Lamp fixing plate (rear)
Fixing heater lamps (L2, L3)