HP (Hewlett-Packard) 9065 Printer User Manual


 
ENWW Stapler section 55
Finisher unit explanation
7 F_CST (SW703 to RB to finisher CB)
Signal from the cartridge SW/F,
indicating whether the cartridge is
properly installed
[L]: Properly installed
[H]: Not properly installed
8 F_LS (SW704 to RB to finisher CB)
Signal from the staple SW/F,
indicating the remaining volume of
staples.
[L]: Sufficient staples.
[H]: Out of staples.
b Finisher CB output signals
1 M709 CONT (finisher CB to RB)
Signal to activate or deactivate M709
[L]: M709 on
[H]: M709 off
2 M709 F/R (finisher CB to RB)
Signal to control the rotation direction
of M709
[L]: CW
[H]: CCW
3 M710 CONT (finisher CB to RB)
Signal to activate or deactivate M710
[L]: M710 on
[H]: M710 off
4 M714 CONT (finisher CB to RB)
Signal to activate or deactivate M714
[L]: M714 on
[H]: M714 off
5 M714 F/R (finisher CB to RB)
Signal to control the rotation direction
of M714
[L]: CW
[H]: CCW
6 M715 CONT (finisher CB to RB)
Signal to activate or deactivate M715
[L]: M715 on
[H]: M715 off
c RB output signals
1 M709 DRV 1 (RB to M709)
Pulse signal to drive/control the
Phase A of M709
2 M709 DRV 2 (RB to M709)
Pulse signal to drive/control the
Phase B of M709
3 M710 F (RB to M710)
Pulse signal to start or stop the
normal rotation of M710
4 M710 R (RB to M710)
Pulse signal to start or stop the
reverse rotation of M710
5 M714 DRV 1 (RB to M714)
Pulse signal to drive/control the
Phase A of M714
6 M714 DRV 2 (RB to M714)
Pulse signal to drive/control the
Phase B of M714
7 M715 F (RB to M715)
Pulse signal to start or stop the
normal rotation of M715
8 M715 R (RB to M710)
Pulse signal to start or stop the
reverse rotation of M715