Filter
Top Products
ENWW Conveyance section 67
Finisher
disassembly/assembly
Conveyance section
Replacing the paper exit roller
(sponge roller)
CAUTION After you have lowered the
main tray, be sure to
unplug the power cord of
the MFP from the power
outlet.
When replacing the
sponge rollers, all of the
five pairs (10 components)
must be replaced.
Procedure
1 Push up the actuator of the main tray exit
with your finger to lower the main tray.
2 Turn the MFP's main power switch (SW1)
off, and unplug the power cord from the
power outlet.
3 Insert the end of the blade screwdriver into
the slot in the sponge roller, and twist the
screwdriver to pry apart.
4 Place the two components of a new
sponge roller around the roller shaft so
that the tabs of the components are
aligned with the dents on the shaft. Press
the components together firmly until you
hear the two “click” sounds.
5 To reattach the sponge roller shaft,
perform the same procedure in reverse
order.
Main tray
Paper exit roller
Actuator
Paper exit roller
(sponge roller)
Paper exit roller (Sponge roller)
Align
Align