Filter
Top Products
ENWW ADF unit 205
MFP disassembly/assembly
Removing and reinstalling the
ADU conveyance roller 1 and 2
WARNING! The interlock, which is
turned off when the front
right or left door opens or
closes, should never be
turned on forcibly with the
ADU stand pulled out.
Removal and reinstallation
of the ADU stand involve
carrying a heavy load so it
should be performed by
two persons.
CAUTION Be sure the power cord has
been unplugged from the
wall outlet.
Procedure
1 Pull out the ADU stand from the MFP.
2 Remove the fuser. See “Fuser” on
page 208.
3 Remove the transfer/separation corona
unit. See “Corona unit” on page 159.
4 Remove the second paper feed unit.
5 Remove the ADU stand.
6 Remove the conveyance unit.
7 Remove the ADU conveyance MC
(MC13).
8 Disconnect the connector (CN407).
9 Remove three screws to detach the
reverse gate solenoid assembly.
10 Remove one screw to remove the
connector cover.
11 Remove three screws to detach the
reverse motor assembly.
12 Disconnect the two connectors (CN403,
404).
13 Disconnect the connector (CN415).
14 Disconnect the connector (CN417).
CAUTION Each inline connector
consists of two male sides
and one female side. Be
sure to remove only the
male side (shown below) of
the connector.
15 Remove one screw to remove the wiring
harness for CN404.
Connector cover
Screws
Reverse motor
assembly
Connector
(CN415)
Screw
Screws
Connector
(CN407)
Reverse gate solenoid assembly