Filter
Top Products
204 MFP disassembly/assembly ENWW
13 Remove the snap rings to remove the
ADU deceleration MC (MC2) and ADU
conveyance MC (MC13).
14 Remove the E-ring at the rear, two belt
holding collars, ADU conveyance belt (1),
and two ADU conveyance pulleys.
15 Remove the pin from each roller shaft.
16 Remove the E-ring and bearing on the
inside of the ADU conveyance pulley.
17 Remove the E-ring on the ADU
conveyance roller (3) shaft.
18 Remove the front E-ring and bearing,
and remove the ADU conveyance roller
(3) and ADU conveyance roller (4) by
sliding them back and forth.
19 Reinstall the above parts following the
removal steps in reverse.
Automatic document
feeder conveyance belt (1)
Bearing E-ring Pin
Belt holding
collars
E-rings
Pin
Bearing
Automatic document feeder
conveyance pulley
Automatic document feeder
conveyance roller (3)
Automatic document feeder
conveyance roller (4)
Bearing
E-rings
E-ring
E-ring