Filter
Top Products
ENWW Paper feed unit of Tray 3 179
MFP disassembly/assembly
Paper feed unit of Tray 3
Removing and reinstalling the
paper feed unit
CAUTION Be sure the power cord has
been unplugged from the
wall outlet.
Procedure
1 Pull out paper feed Tray 3.
2 Loosen the securing shaft screw, and
remove one screw.
3 Disconnect the inline connector (CN854)
and remove the paper feed unit by lifting.
4 Reinstall the above parts following the
removal steps in reverse.
Removing and reinstalling paper
feed Tray 3
WARNING! When removing the tray,
stand in a proper position
so that you do not hurt your
back and waist. If the tray
contains paper, remove all
paper before removing the
tray.
CAUTION Be sure the power cord has
been unplugged from the
wall outlet.
Procedure
1 Pull out paper feed Tray 3.
2 Remove the paper feed unit.
3 Remove four screws and remove Tray 3 by
lifting.
4 Reinstall the above parts following the
removal steps in reverse.
Removing and reinstalling the
paper pick roller and pick roller
rubber
Procedure
1 Remove the paper feed unit.
2 Remove two snap rings and slide the two
bearings outward.
Relay connector (CN854)
Securing shaft screw
Paper feed unit
Screw
Tray 3
Screws