Filter
Top Products
70 Finisher disassembly/assembly ENWW
Main tray section
Replacing the tray up/down motor
(M703)
CAUTION Make sure that the power
cord of the MFP is
unplugged from the power
outlet.
When removing the tray
up/down motor, be sure to
hold the main tray to
prevent it from falling.
Procedure
1 Remove the rear cover.
2 Remove the connector. Remove two
mounting screws while holding the main
tray, and then detach the tray up/down
motor (M703).
3 Reinstall the above parts following the
removal steps in reverse.
Replacing the up/down wire
CAUTION Make sure that the power
cord of the MFP is
unplugged from the power
outlet.
When removing the tray
up/down motor, be sure to
hold the main tray to
prevent it from falling.
Note The wire replacing procedure
described below is of the rear
side. For the front side, the
design as well as the winding
direction of the wire is
symmetrical.
CAUTION “F” is impressed on the
front side surface of the
wire bracket. Also, “R” is
impressed on the rear side
surface.
Be sure of the direction
when installing.
Procedure
1 Remove the following parts:
•Side cover
• Front door
• Rear cover
• Tray up/down motor (M703)
•Main tray
Screw