HP (Hewlett-Packard) 9065 Printer User Manual


 
ENWW Fuser 213
MFP disassembly/assembly
5 Pull out the fusing heater lamp (L4) from
the front side of the fusing lower roller.
6 Reinstall the above parts following the
removal steps in reverse.
CAUTION When installing the lamp,
pay attention to its
orientation. The lamp
cannot be installed
properly if it is facing the
opposite direction.
Removing and reinstalling the
fusing separation claw (upper)
unit and fusing separation claws
(upper)
Procedure
1 Remove the fuser.
2 Remove the fuser front cover.
3 Remove the web cover.
4 Remove the screw to detach the fixture.
5 Remove the fusing separation claw
(upper) unit
6 Remove the screw to remove the upper
separation claw support shaft from the
fusing separation claw (upper) unit.
CAUTION Be careful when removing
the shaft because it bends
easily.
7 Remove six springs attached to the fusing
separation claw (upper) unit.
8 Remove six fusing separation claws
(upper).
Fixing heater lamp (L4)
Fixing separation claw
(upper) unit
Fixture
Screw
Screw
Separation claw
(upper) support shaft
Spring
Fixing separation
claw (upper) (6)