Filter
Top Products
ENWW Stapler section 79
Finisher
disassembly/assembly
4 Remove four mounting screws securing
the stapler and the screw holding the
ground cable. Detach the stapler/F and
the connector (CN181).
5 Remove two screws holding the sensor
cover of the stapler/R. Remove the screw
securing the ground cable. Detach the
connector (CN182) of the stapler rotation
hp PS (PS713).
6 Remove four screws. Detach the stapler/R
and the connector (CN180).
CAUTION Take care not to damage
the stapler rotation hp PS
(PS713) when removing
the stapler/R.
7 Reinstall the above parts following the
removal steps in reverse.
CAUTION When installing the sensor
cover of the stapler/R, take
care that the bundled cable
does not disturb the stapler
rotation HPPS (PS713)
and is not nipped by the
gears.
Ground
Screw securing the ground cable
Connector
(CN181)
Stapler/F
Screw
Ground
Screw securing the
ground terminal
Connector
(CN182)
Stapler/R
Screw
Sensor cover
Stapler rotation
HP PS (PS713)
Connector (CN180)
Stapler/R
Screw
Stapler rotation HP
PS (PS713)