Filter
Top Products
ENWW ADF unit 189
MFP disassembly/assembly
3 Using a blower brush, clean the paper
dust removing brush.
4 Reinstall the above parts following the
removal steps in reverse.
CAUTION When installing, align the
projection on the paper
dust removing brush with
the positioning hole on the
second paper feed unit.
Cleaning the paper mis-centering
PS (PS70)/leading edge PS (PS43)
WARNING! The interlock, which is
turned off when the front
right or left door opens or
closes, should never be
turned on forcibly with the
ADU stand pulled out.
CAUTION Be sure the power cord has
been unplugged from the
wall outlet.
Procedure
1 Pull out the ADU stand from the MFP.
2 Open the pre-transfer jam handler. Clean
the sensor of the paper mis-centering PS
(PS70) and leading edge PS (PS43) at the
rear of the pre-transfer jam handler using
a drum cleaner or cleaning pad.
3 Reinstall the above parts following the
removal steps in reverse.
Positioning holes
Brush handles
Lock lever
Projections
Lock lever
Second paper feed unit
Paper dust
removing
brush
Paper dust removing brush
Cleaning area
Paper mis-centering PS (PS70)
Pre-transfer jam
handler
Leading edge
PS (PS43)