Filter
Top Products
May 2003 Installing the 201i server in the Succession CSE 1000 system
Part 2: 201i Server Hardware Installation 103
Installing the 201i server
Introduction
This section describes how to install the 201i server inside the Media
Gateway or Media Gateway Expansion.
Before you begin
Determine which pair of consecutive slots will contain the 201i server. The
following table identifies the Media Gateway and Media Gateway
Expansion slots into which the CallPilot 201i server can be installed:
Note: The 201i server will not function properly if it is installed in slots 3
and 4.
For more information about card slots, refer to the Succession
Communication Server for Enterprise 1000 Planning and Installation Guide
(NTP 553-3023-210).
For the logical slot numbers that you must use when you configure the
Succession CSE 1000 system, see “Card slots” on page 93.
Unit
The 201i server
can be installed in Ineligible slots
Media Gateway Slots 1 and 2
Slots 2 and 3
Slot 0 is dedicated to the SSC card.
Slot 4 (includes slots 5 and 6) is
not used.
Media Gateway
Expansion
Slots 7 and 8
Slots 8 and 9
Slots 9 and 10
Slot 10 is a double-wide slot. The
second half of this slot does not
have a backplane connector.