Filter
Top Products
May 2003 Preparing peripheral devices
Part 2: 201i Server Hardware Installation 125
To set the CD-ROM drive’s DIP switches
Set the CD-ROM drive’s DIP switches as described in the following table:
What’s next?
If you are also installing a tape drive, set the tape drive’s SCSI ID (see page
126); otherwise, set the CD-ROM drive’s device termination (see page 128).
DIP switch Description Setting
1ParityON
2TerminationNote: For more information about daisy
chaining SCSI devices, see “Setting SCSI
device termination” on page 128.
If the CD-ROM drive is the first and only
device, set this switch to ON.
If the CD-ROM drive is the first device
and daisy chained with the tape drive, set
this switch to OFF.
3 Test OFF (for factory use only)
4BlockOFF
5EjectOFF
Note: If this switch is set to ON, the eject
button on the CD-ROM drive is disabled.
To eject the CD-ROM from the drive, a
software eject command must be sent over
the SCSI bus.