Filter
Top Products
Installing the 201i server in an Option 11C or Option 11C Mini Standard 1.0
86 CallPilot
Installing cables on the back of the
Option 11C Mini cabinet
Introduction
The following items connect to the back of the Option 11C Mini cabinet:
multi I/O cable (NTRH0912)
Option 11C Mini power cord with two ferrites
You must connect the multi I/O cable first before connecting the power cord,
because the power cord routes over the multi I/O cable connection.
Before you begin
Ensure that you have the Option 11C Mini EMC Kit (NTRH3503). The kit
contains ferrites that you must install on the Option 11C Mini’s power cord
to maintain Option 11C Mini EMC requirements.
If you do not have the kit, contact your Nortel Networks distributor.
To connect the cables
1 On the rear of the Option 11C Mini cabinet, locate the connector
associated with the first slot occupied by the 201i server.
2 Connect the NTRH0912 multi I/O cable as follows:
a. Loosen the connector’s Velcro fastening strap.
b. Connect the amphenol connector on the NTRH0912 multi I/O cable to
the connector on the back of the Option 11C Mini cabinet.
c. Secure the connection by tightening the connector’s retaining screw
and Velcro fastening strap.