Filter
Top Products
May 2003 About the 201i server
Part 2: 201i Server Hardware Installation 25
Peripheral connectivity
Introduction
Peripheral equipment is attached to the 201i server on the server faceplate.
Faceplate connections
The following peripheral devices connect to the 201i server’s faceplate:
monitor (SVGA)
keyboard
mouse
MPC card (permanent connection)
SCSI cable (permanent connection)
Monitor, keyboard, and mouse
You must connect a monitor, keyboard, and mouse to run the Configuration
Wizard or to install the operating system on the 201i server as part of a
recovery process.
All three peripheral components are hot-pluggable.
ATTENTION
Connections made to the faceplate (with the exceptions
noted below) are temporary only, since you must remove
the cabinet cover to make these connections. The system
does not meet specifications for radiated EMI if you
remove the cabinet cover.