Filter
Top Products
Connecting peripheral devices to the 201i server Standard 1.0
140 CallPilot
Installing the monitor, keyboard, and
mouse
Introduction
You must connect the monitor, keyboard, and mouse to the 201i server so
that you can
observe the 201i server startup process
run the Configuration Wizard
perform initial administration after installation
Note: The 201i server is not intended to operate with permanent monitor,
keyboard, and mouse connections. Once you have successfully started and
configured the 201i server, remove the monitor, keyboard, and mouse. For
day-to-day administration, use a web browser on a PC that is connected to
the ELAN or CLAN.
Hardware requirement
.
CAUTION
Risk of equipment damage
The mouse connector on the 201i faceplate is a PS/2 connector.
If you plan to use a USB mouse with USB-to-PS/2 converter,
you must also use the Nortel Networks-supplied 4-inch PS/2
extension cable (A0855616).
Without the extension cable, the USB-to-PS/2 mouse connector
is partially blocked by the monitor connector.