Filter
Top Products
Connecting peripheral devices to the 201i server Standard 1.0
156 CallPilot
2 Attach the serial cable as follows:
a. Connect the 25-pin male end of the serial cable to the modem.
b. Attach the 0.25-inch nuts to the thumbscrews on the 9-pin female
connector on the serial cable.
c. Connect the 9-pin female connector to the RS-232 COM1 connector
on the multi I/O cable and tighten the nuts.
3 Connect one end of the RJ-11 phone cord to the line jack on the modem
and the other end to an analog jack.
4 Plug the power cord into an electrical outlet with an isolated ground.
5 Plug the other end of the power cord into the modem’s power connector.
Result: The back of the modem appears similar to the following:
.
CAUTION
Risk of equipment damage
Connect the modem to an analog line only. The use of a
non-analog line (for example, digital or Multiline) will
damage the modem.
G101445
RJ-11
connection
DIP
switches
Switch positions:
Serial cable
(RS-232)
connection
Power
connection
12345678
12345678
OFF
ON