Filter
Top Products
May 2003 Installing the 201i server in a large Meridian 1 system
Part 2: 201i Server Hardware Installation 53
Remove the tie wraps where applicable to free the cable.
c. Remove the connector, I/O filter assembly, and all mounting hardware
from the inside of the I/O panel so the slot is completely vacated.
Retain the mounting hardware (that is, screws, tie wrap base,
standoffs, and so on). You will reuse this hardware to fasten the
NTRH3501 cable.
4 Repeat step 3 to remove the existing backplane cable for the right slot.
Store the cable, I/O filter assembly, and mounting hardware for this cable
with your Meridian 1 spares. You will not use them with the 201i server.
ATTENTION
If you attempt to pull the connector off without
pressing the lock tab, you may pull the connector
shroud off the backplane. If this happens, refer to
the adjacent connectors for correct key positioning,
and then replace the connector shroud.