Filter
Top Products
Installing the 201i server in the Succession CSE 1000 system Standard 1.0
114 CallPilot
Connecting cables to the Succession
CSE 1000 system
Introduction
The following items are connected to the back of the Media Gateway or
Media Gateway Expansion:
multi I/O cable (NTRH0912)
This cable establishes the connection to the modem, ELAN, and CLAN.
Media Gateway or Media Gateway Expansion power cord with two
ferrites
You must connect the multi I/O cable first before connecting the power cord,
because the power cord routes above the multi I/O cable connection.
Before you begin
Ensure that you have the EMC Kit (NTRH3503). The kit contains ferrites
that must be installed on the Media Gateway or Media Gateway Expansion’s
power cord to maintain EMC requirements.
If you do not have the kit, contact your Nortel Networks distributor.
To connect the cables
1 On the rear of the Media Gateway or Media Gateway Expansion, locate
the connector associated with the first slot occupied by the 201i server.
2 Connect the NTRH0912 multi I/O cable as follows:
a. Loosen the connector’s Velcro fastening strap.
b. Connect the amphenol connector on the NTRH0912 multi I/O cable to
the connector on the back of the Media Gateway or Media Gateway
Expansion.