Filter
Top Products
May 2003 About the 201i server
Part 2: 201i Server Hardware Installation 23
The following table identifies the purpose of each connector on the
NTRH0912 multi I/O cable.
Note: Labels on the RJ-45 cables distinguish the CLAN and ELAN
connectors.
Connector type Purpose
50-pin amphenol This connector establishes the connection between
the Meridian 1 or Succession CSE 1000 Media
Gateway or Media Gateway Expansion backplane,
ELAN and CLAN hubs, and modem.
10Base-T
(RJ-45)
This connector provides a 10 Mbit/s Ethernet
connection between the 201i server and the
Meridian 1 switch or Succession CSE 1000 system.
This connection allows the exchange of call control
information between the server and the Meridian 1
switch or Succession CSE 1000 system.
For more information about the ELAN, see “About
the ELAN” in Part 1 of the CallPilot Installation and
Configuration binder.
10/100Base-T
(RJ-45)
This connector provides a network connection for
users’ desktop computers, to enable them to use
the unified messaging and fax messaging features
LAN-based server administration
ATTENTION
If you need Ethernet 100Base-T operation at
100 Mbit/s on large Meridian 1 systems (such as
Option 51), you must install the NTRH3501
backplane (tip and ring) cable. For more information,
see Chapter 3, “Installing the 201i server in a large
Meridian 1 system.”