Filter
Top Products
Installing the 201i server in a large Meridian 1 system Standard 1.0
60 CallPilot
Before you begin
Before you install the SCSI devices in a daisy chain, you must configure the
SCSI device IDs and DIP switches. For instructions, refer to Chapter 6,
“Preparing peripheral devices.”
To install the SCSI cables for Meridian 1
1 Thread the SCSI connector end of the NTRH1408 cable from the front of
the Meridian 1 along the bottom of the shelf to either the left or the right
access channel.
2 Leave the low-profile right-angle SCSI connector hanging for now. You
will connect it later to the 201i server faceplate.
Note: The following diagram shows what the connection looks like after
the cable is connected:
G101556
Access channels
to rear of cabinet
201i server
Intermediate
SCSI cable
NTRH1408