Filter
Top Products
Installing the 201i server in the Succession CSE 1000 system Standard 1.0
112 CallPilot
1 Insert the bottom tabs of the front cover plate inside the bottom rail.
2 Align the screw holes on the front cover plate over the screw heads on
the Media Gateway or Media Gateway Expansion.
3 Slide the front cover plate downward to the right, ensuring that the side
tabs slide behind the side rail.
4 Tighten the screws to secure the front cover plate.
5 Continue with “To replace the front bezel,” below.
To replace the front bezel
1 Align the two posts and the locking tab on the rear of the front bezel with
the slots on the inside front cover plate.
.
WARNING
Risk of eye injury
Nortel Networks recommends that you operate the Media
Gateway and Media Gateway Expansion with their front bezels
installed. When the blue LEDs inside these units are lit, they
are very bright. Avoid staring at them.
G101622