Filter
Top Products
Preparing peripheral devices Standard 1.0
128 CallPilot
Setting SCSI device termination
Introduction
If you will be connecting SCSI devices in a daisy chain, the last device in
the daisy chain must be terminated. This section describes how to terminate
the SCSI devices.
Supported daisy chain connection scenarios
The first device in a SCSI device daisy chain can be either the tape drive or
the CD-ROM drive. However, since the Tandberg SLR5 tape drive is already
internally terminated at the factory, Nortel Networks recommends that you
connect the tape drive as the last device.
The following diagrams show the supported daisy chain and SCSI cable
connections for your switch. The CD-ROM drive is the first device in the
daisy chain. The tape drive is the last device.
ATTENTION
Ensure that the CD-ROM and tape drives are powered
down before changing the device termination.