Filter
Top Products
Connecting peripheral devices to the 201i server Standard 1.0
158 CallPilot
Completing the installation
Introduction
To complete the installation of the 201i server, lock the 201i into position.
The server starts up automatically.
To complete the installation and start the 201i server
Note: Ensure that the switch in which the 201i is installed is powered on.
1 Ensure that all peripheral devices are powered up (including the IPE
shelf).
2 Push the 201i server gently but firmly until it is flush with the backplane.
Result: The 201i server beeps for three seconds to indicate that power
is being received.
3 Close the lock latches to secure the 201i server to the backplane.
4 Ensure that the power status LED is lit.
5 Watch the HEX display on the 201i server.
The HEX display shows T:01 through T:08, and then HOST. This takes
about 13 seconds.
6 When the following menu appears on the monitor, select option 1 to start
Windows NT:
Please select the operating system to start:
--------------------------------------------
Windows NT Server Version 4.00
Windows NT Server Version 4.00 (VGA mode)
Previous OS on C
Choose an option[1,2]?1