Filter
Top Products
May 2003 About the 201i server
Part 2: 201i Server Hardware Installation 27
Set the SCSI ID for the CD-ROM drive to 3. If you are connecting more
than one SCSI device to the server (such as a tape drive), you must daisy
chain those devices.
Note: The CD-ROM drive is not hot-pluggable. You must power off the
server to connect or disconnect the drive.
Tape drive (NTRH9038)
An external SCSI tape drive is used to back up and restore data. The device
connects to the server by an intermediate SCSI cable that connects to the
SCSI connector on the faceplate.
Since the tape drive is an external device, it requires an AC power source.
Set the SCSI ID for the tape drive to 5. If you are connecting more than one
SCSI device to the server (such as a CD-ROM drive), you must daisy chain
those devices.
Note: The tape drive is not hot-pluggable. You must power off the server to
connect or disconnect the drive.
Modem
An external modem provides remote access to the 201i server. The modem
connects to the RS-232 COM1 connector on the multi I/O cable.
Since the modem is an external device, it requires its own AC power source.
Two modems are supported:
33.6 Kbps modem: (NTRH9016)
56 Kbps modem: (NTRH9078)
10Base-T Ethernet hub
The 10Base-T Ethernet hub provides the ELAN connection between the
201i server and the Meridian 1 switch or Succession CSE 1000 system.
Since the hub is an external device, it requires an AC power source.