Filter
Top Products
Preparing peripheral devices Standard 1.0
124 CallPilot
Setting the CD-ROM drive’s SCSI ID and
DIP switches
Introduction
This section describes how to set the CD-ROM drive’s SCSI ID and DIP
switches.
Note: The CD-ROM drive discussed in this section is the Plextor UltraPlex
external SCSI CD-ROM drive (NTRH9037).
To set the CD-ROM drive SCSI ID
The SCSI ID setting is located on the back of the CD-ROM drive. (See the
diagram that follows.)
To change the SCSI ID, use the blade of a screwdriver to rotate the SCSI ID
dial’s arrow to 3.
ATTENTION
You must power down the CD-ROM drive before
changing the SCSI ID and DIP switches.
G101176
SCSI-Out
SCSI-In
SCSI ID
RL
12345
SCSI interface
connectors - in and out
AC power input
Power
switch
SCSI IDDIP
switches
PARITY
TERM
TEST
EJECT
BLOCK