100 Configuring KIRK Wireless Server 600v3
14117800, Ed.2
7.6.1.8 Configuring DECT Master (Primary)
On the Master page you can define which mode the KIRK Wireless Server 600v3 should operate
in. You also establish a communication protocol between the Master KIRK Wireless Server 600v3
and a call handler.
1 Under the Configuration menu, click DECT, and then click Master.
Figure 52 Adm. Page: Configuration/DECT/Master page
2 From the Mode list, select Active. Selecting Active defines the KIRK Wireless Server 600v3
as a Primary (Master).
3 In the GK (Gate Keeper) field, type the IP address of your call handler.
Contact your system administrator for more information.
4 In the Alt-GK (Alternative Gate Keeper) field, type an alternative IP address of your call
handler (optionally).
Contact your system administrator for more information.
5 From the Prot (Protocol) list, select either H323, SIP or SKINNY depending on the protocol
you are using.
6 Click OK.
7 Click Reset (under Administration menu) to save your configuration.