Filter
Top Products
146 Configuring KIRK Wireless Server 600v3
14117800, Ed.2
•In the Host Name field, type the host name of the KIRK Wireless Server 600v3.
The host name consist of ip1200- followed by the last three octets of the MAC address of
the KIRK Wireless Server 600v3 (to be found on the label on the rear of the KIRK
Wireless Server 600v3). Eg. ip1200-0f-01-9d
Note: When clicking the Get button, the system provides the host name automatically.
The Get button can only be used, if working online and if the IP address is the specific IP
address of the KIRK Wireless Server 600v3 in question and valid on the whole network.
2 In the LDAP area:
•In the Primary field, type the IP address of the primary LDAP Server.
•In the Alt field, type the IP address of the alternative LDAP Server.
3 In the Radio area:
•In the Master field, type the IP address of the Master KIRK Wireless Server 600v3.
•In the Alt Master field, type the IP address of the alternative (Standby) Master KIRK
Wireless Server 600v3.
Note: The radio ID of the KIRK Wireless Server 600v3 is by default identical to the last octet
of its IP address. It is recommended not to change the radio ID.
4 Save the configuration now or wait until you have finished configuring the whole installation.
For more information about saving the configuration, refer to “Saving Configurations” on
page 150.