Filter
Top Products
44 Installing the KIRK Wireless Server 600v3
14117800, Ed.2
4.2.5 KIRK Wireless Server 600v3 - Reset Button
It is possible to restart or reset the KIRK Wireless Server 600v3 by pressing the Reset button on
the faceplate of the KIRK Wireless Server 600v3. For description of the faceplate, refer to
“Faceplate” on page 43.
4.2.5.1 Resetting the KIRK Wireless Server 600v3 Hardware
This section contains description of the different actions that take place when pressing the Reset
button.
Table 4 Reset Button Description
Press button Action
Short press Restarts the KIRK Wireless Server 600v3.
Press until LED flashes
fast
Restarts the KIRK Wireless Server 600v3 in TFTP
mode (Trivial File Transfer Protocol). In TFTP mode
the KIRK Wireless Server 600v3 can be reached
only through the GWLOAD program. For more
information about using the GWLOAD program,
refer to
“Using the GWLOAD Program” on page
199.
Press for a longer period Performs a system reset and configuration preset.
The Alarm Indicator and Ready Indicator indicate
that you are about to perform a system reset
including a configuration preset within a couple of
seconds if the reset button is not released.
All system settings will be erased and the system
returns to its default settings. The actual software
will not be affected.
Note: After a system reset you must perform at
short press on the Reset button again, to prevent
the system to start up in DHCP client mode.