Filter
Top Products
116 Configuring KIRK Wireless Server 600v3
14117800, Ed.2
7.6.4.2 Assigning a Specific IP Address (Secondary)
To assign a specific IP address to the KIRK Wireless Server 600v3, it is necessary to disable the
DCHP mode and then assign a specific IP address to the KIRK Wireless Server 600v3. The new IP
address and network address will be provided by the system administrator.
Note: It is advisable that the IP addresses for KIRK Wireless Server 600v3 secondaries are
numbered in succession; eg. 192.168.1.
3, 192.168.1.4, 192.168.1.5 etc. This makes it easier to
detect a specific Secondary KIRK Wireless Server 600v3.
1 Under the Configuration menu, click ETH0, and then click DHCP.
Figure 69 Adm. Page: Configuration/ETH0/DHCP page
2 From the Mode list, select Disabled, and then click OK.
3 Click Reset (under Administration menu) to save your configuration.
4 Under the Configuration menu, click ETH0, and then click IP.
Note: It is necessary to use the ETH0 port when integrating the KIRK Wireless Server 600v3
on the local network.