Filter
Top Products
Preparing KIRK Handset for Use 65
KIRK Wireless Server 600v3 Installation and Configuration Guide
6.3 Installing Battery
Read the following information before you handle the batteries:
• Do not replace the batteries in potentially explosive environments, such as rooms where
flammable liquids or gases are present.
• The battery will explode if disposed of in a fire.
• Do not charge the batteries unless you use the KIRK approved charger and the proper
batteries.
• Only use battery type 84743411 in the KIRK 4020 and KIRK 4040. Do not use these batteries
with other products. These batteries were designed specifically for use with the KIRK 4020
and KIRK 4040 and the KIRK Charger ONLY. Improper use of the batteries may result in fire
hazard.
• Only use battery type 84743416 in the KIRK 4080. Do not use this battery with other
products. This battery was designed specifically for use with the KIRK 4080 and the KIRK
Charger ONLY. Improper use of the battery may result in fire hazard.
• Do not do anything that would cause the battery to short circuit.
Do not let the battery or the charger come into contact with conductive metal objects.
6.3.1 Installing Battery on KIRK 3040 Handsets
Note: The battery is connected to the handset when it is shipped from the factory.
1 To change the battery press down the back cover and push it 5 mm towards the headset plug.
Figure 19 Remove Back Cover from Handset
2 Lift off back cover.
3 Place the battery plug in the slot in the battery box.
4 Insert battery with the label readable.
5 Replace the back cover.