Filter
Top Products
186 System Management
14117800, Ed.2
10.1.8.2 Updating Firmware
The software of the KIRK Wireless Server 600v3 can be updated. To update the software you load
a file to the system. Contact your distributor for newest software.
1 Under the Administration menu, click Upload, and then click Firmware.
Figure 131 Adm. Page: Administration/Upload/Firmware page
2 Click Browse.
A dialog box appears.
3 Select the firmware in question, and then click Open.
4 Click Upload.
Wait until the system has finished updoading.
Note: Do not interrupt firmware upload. If this process is interrupted, the firmware in the
KIRK Wireless Server 600v3 will be defect.
Note: If the firmware upload is interrupted, the firmware must be uploaded again before
rebooting the system.
5 Click either Reset Immediately or Idle Reset.
When resetting the KIRK Wireless Server 600v3 immediately, all calls are terminated and the
KIRK Wireless Server 600v3 is reset. When resetting the KIRK Wireless Server 600v3 when
the system is idle, the reset is done when there are no active calls in the KIRK Wireless Server
600v3.