Filter
Top Products
Configuring KIRK Wireless Server 600v3 103
KIRK Wireless Server 600v3 Installation and Configuration Guide
7.6.2 Configuring Sync Master
This section describes how to configure a Sync Master KIRK Wireless Server 600v3 in a
multi-cell solution.
KIRK Wireless Server 600v3 primary and secondaries uses the existing DECT air interface to
synchronize to each other on. One KIRK Wireless Server 600v3 is configured as a Sync
(synchronization) Master in the system. It is not necessary to configure what KIRK Wireless
Server 600v3 the Sync Master should synchronize to.
This section includes information about:
• “Assigning a Specific IP Address (Sync Master)” on page 103
• “Configuring LDAP Replicator (Sync Master)” on page 105
• “Configuring DECT Master (Sync Master)” on page 106
• “Configuring DECT Radio (Sync Master)” on page 107
For information on accessing the web based Administration Page, refer to “Accessing the Web
Based Administration Page” on page 75.
7.6.2.1 Assigning a Specific IP Address (Sync Master)
To assign a specific IP address to the KIRK Wireless Server 600v3, it is necessary to disable the
DCHP mode and then assign a specific IP address to the KIRK Wireless Server 600v3. The new IP
address and network address will be provided by the system administrator.
1 Under the Configuration menu, click ETH0, and then click DHCP.
Figure 55 Adm. Page: Configuration/ETH0/DHCP page
2 From the Mode list, select Disabled, and then click OK.
3 Click Reset (under Administration menu) to save your configuration.