Filter
Top Products
132 Configuring KIRK Wireless Server 600v3
14117800, Ed.2
2 In the Gatekeeper area:
•From the Mode list, select Active.
•In the Gatekeeper field, type the IP address of your call handler.
Contact your system administrator for more information.
•In the Alternative Gatekeeper field, type an alternative IP address of your call handler
(optionally).
Contact your system administrator for more information.
•From the Protocol list, select either H323, SIP or Skinny depending on the protocol you
are using.
3 In the System area:
•In the AC field, type an authentication code (optionally).
•From the Subscriptions list, select either Allow Anonymous, With User AC only, or
Diabled.
Note: It is recommended to select With User AC only. When subscribing a new handset
to the system it is possible to use an authentication code (AC). If you want to use the
authentication code, you must select With User AC only. For more information about
subscription of handsets and authentication codes, refer to “Subscribing Handsets” on
page 162.
•From the Coder list, select a voice compression value that matches your telephony
infrastructure.
Contact your system administrator for more information.
•From the Tones list, select a ring tone.
4 In the Radio area:
•In the Radio-Id field, type 1.
5 Save the configuration.
For more information about saving the configuration, refer to “Saving Configurations” on
page 150.