52 KIRK Repeater Installation
14117800, Ed.2
5.5 Recording the Installation Information
After completing the installation of the KIRK Repeaters, record the location of each KIRK
Repeater.
5.6 Checking Indicators
• Verify that the KIRK Repeater LED indicator is continuously on, indicating that the repeater is
functional.
5.7 Powering the KIRK Repeater
5.7.1 Power Options
The KIRK Power Supply for the KIRK Repeater should be 9VDC, 300mA.
5.8 Programming a KIRK Repeater with the KIRK Programming Kit
This section provides information about:
• “Content of the KIRK Programming Kit Repeater” on page 52
• “Set up of the Hardware for Repeater Programming” on page 53
• “Programming the KIRK Repeater with the ServiceTool” on page 53
5.8.1 Content of the KIRK Programming Kit Repeater
The KIRK Programming Kit Repeater (Part no. 02319508) consists of:
• splitter
• serial cable
Note: For programming the KIRK Repeater you also need the programming software
(ServiceTool) and the KIRK Power Supply for the repeater. The ServiceTool is not part of the
KIRK Programming Kit Repeater but can be downloaded from www.kirktelecom.com. The KIRK
Power Supply for the repeater is to be ordered separately (Part no. UK version: 84642421, Part no.
EU version: 84642420).