Filter
Top Products
Configuring KIRK Wireless Server 600v3 131
KIRK Wireless Server 600v3 Installation and Configuration Guide
Figure 84 KIRK Configuration Tool: Master tab
1 In the IP Address area:
• Deselect the DHCP check box.
First time you power up the KIRK Wireless Server 600v3 it acts as a DHCP client. To
assign a specific IP address to the unit, it is necessary to disable the DHCP mode.
•In the IP Address field, type the IP address of the KIRK Wireless Server 600v3, provided
by your system administrator.
This IP address is now the default address when accessing the KIRK Wireless Server
600v3.
•In the Network Mask field, type the network mask.
•In the Default Gateway field, type the IP address of the gateway.
•In the Host Name field, type the host name of the KIRK Wireless Server 600v3.
The host name consist of ip1200- followed by the last three octets of the MAC address of
the KIRK Wireless Server 600v3 (to be found on the label on the rear of the KIRK
Wireless Server 600v3). Eg. ip1200-0f-01-9d
Note: When clicking the Get button, the system provides the host name automatically.
The Get button can only be used, if working online and if the IP address is the specific IP
address of the KIRK Wireless Server 600v3 in question and valid on the whole network.