Filter
Top Products
3.30 SETUP 3 Tests and Diagnostics
PORTEGE A200 Maintenance Manual (960-499) 3-97
8. Configuration
This option lets you set the device configuration.
All Devices BIOS sets all devices.
Setup by OS Initializes devices, which is needed to load an operating
system. Operating system initializes other devices. When
this option is selected, the setting in the “PC Card”
becomes “Auto-Selected” and it can not be changed.
(Default)
Note: When using installed OS, selecting “Set by OS” is recommended. But, when
setting “PC CARD-Controller Mode” to other than “ Auto-Selected”, select
“All Devices”.
9. Drives I/O
This option displays the address and interrupt level for hard disk drive and optical disk
drive. It is for information only and cannot be changed.
Built-in HDD This cannot be changed.
CD-ROM This cannot be changed. This is not displayed when a drive
is not built-in.
PC-card Displays an address and interrupt level only when the
system has been booted by a PC-card type HDD.
10. PCI Bus
This option displays the interrupt level for the Card Bus in the computer. It is for information
only and cannot be changed.
PCI BUS = IRQ10, IRQ11
11. PC Card
This option displays the PC Card Controller mode. When “Device Config.” is set to “All
Devices”, it can be changed.
Auto-Selected Use this setting when OS supports Plug&Play. (Default)
PCIC Compatible Use this setting when Card Bus does not work properly in
“Auto-Selected” or PC card supports 16-bit.