Open as PDF
4 Replacement Procedures 4.15 Cover assembly
4-34 PORTEGE A200 Maintenance Manual (960-499)
Installing a cover assembly
To install a cover assembly, perform the following procedure. (See Figure 4-21 to 4-24.)
1. Connect the LED cable to the connector PJ9500 on the system board.
2. Mount the cover assembly on the base assembly while engaging the latches.
3. Fix the cover assembly with the following screws.
? M2?3C S-THIN HEAD screw ?1
(in the battery slot)
? M2.5?12B FLAT HEAD screw ?5 (?)
? M2.5?8B BIND screw ?8 (?)
? M2.5?4B FLAT HEAD screw ?2 (?)
? M2.5?12B FLAT HEAD screw ?1 (?’)
(When the optical drive is not removed.)
4. Connect the LCD cable to the connectors PJ5600 on the system board.