Filter
Top Products
- 185 -
(4) Feed speed
• A feed is performed at the designated speed.
However, the back feed speed in the cut mode or the strip mode is 3 ips. This
back feed speed can be changed from 3 ips to 2 ips in the system mode.
• For B-SX4T, the print speed “10 ips” is not supported for printing with the rotary
cutter. If “10 ips” is specified when the rotary cutter has been installed, the
print speed is corrected from 10 ips to 6 ips, regardless of the cut designation.
• The possible issue speed varies according to types and sizes of the paper
supply. For details, refer to the Supply Specification.
Model B-SX4T B-SX5T
Parameter
Rotary cutter
not installed
Rotary cutter
installed
1
2 3 ips 3 ips 3 ips
3
4
5 5 ips
6 6 ips
7 6 ips
8
9 10 ips 8 ips
A
(5) With/without ribbon
Without ribbon: The ribbon motor is not operated at feed.
With ribbon: The ribbon motor is operated at feed.
With ribbon saving: When the use of the ribbon saving system is set to ON
(used) in the system mode, ribbon saving will be performed
automatically.
When “without ribbon saving” is selected, or the use of the
ribbon saving system is set to OFF (not used) in the system
mode, ribbon saving will not be performed.