Filter
Top Products
- 269 -
9.1.2 DETAIL STATUS
Detail Status
LCD Message of
Upper Line
(English)
Printer Status
Auto Status
Transmission
Status
Request
Command
ON LINE
The head was closed with the head open. 00 00
HEAD OPEN
The head was opened in the online mode. 01 01
ON LINE
Operating (Analyzing command, drawing, printing,
feeding)
– 02
PAUSE ****
In a pause state – 04
ON LINE
Waiting for stripping – 05
Display of error message
(See NOTE 1.)
A command error was found in analyzing the
command.
06 06
COMMS ERROR
A parity error or framing error occurred during
communication by RS-232C
07 07
PAPER JAM ****
A paper jam occurred during a paper feed. 11 11
CUTTER ERROR****
An abnormal condition occurred at the cutter. 12 12
NO PAPER ****
The label has run out. 13 13
NO RIBBON ****
The ribbon has run out. 14 14
HEAD OPEN ****
An attempt was made to feed or issue with the
head open (except the [FEED] key)
15 15
HEAD ERROR ****
A broken dot error has occurred in the thermal
head.
17 17
EXCESS HEAD TEMP
The thermal head temperature has become
excessively high.
18 18
RIBBON ERROR****
An abnormal condition occurred in the sensor for
determining the torque for the ribbon motor.
21 21
REWIND FULL ****
An overflow error has occurred in the rewinder. 22 22
ON LINE
Ribbon near end state (Online) – 27
PAUSE
Ribbon near end state (In a pause state) – 28
ON LINE
Ribbon near end state (Operating) – 29
ON LINE
A label issue has been completed normally. 40 –
ON LINE
A feed has been completed normally. 41 –
ON LINE
A head broken dots check has been completed
normally.
00 –
SAVING #### &&&&
In writable character or PC command save – 55
SAVING %%%%%%%
mode
FLASH WRITE ERR.
An error has occurred in writing data into memory
for storage.
50 50
FORMAT ERROR
An erase error has occurred in formatting memory
for storage.
51 51
FLASH CARD FULL
Saving failed because of the insufficient capacity of
memory for storage.
54 54
POWER FAILURE
A momentary power interruption has occurred. – –
INITIALIZING...
The memory card for storage is being initialized.
(Initialization is carried out for a max. of
approximately 15 seconds)