Filter
Top Products
- 367 -
c How to send control code data:
SOH (01H) → >A (3EH, 41H)
STX (02H) → >B (3EH, 42H)
to
GS (1DH) → >] (3EH, 5DH)
RS (1EH) → >^ (3EH, 5EH)
US (1FH) → >_ (3EH, 5FH)
d How to send a special code:
> (3EH) → >0 (3EH, 30H)
e How to send a Kanji code:
Shift JIS
JIS hexadecimal
(For details, refer to the section for the Bar Code Data Command.)
NOTE: “NUL” code in the table cannot be used, however, it can be designated.
If it is designated, data following “NUL” code is not printed.
When the MaxiCode specification setting is set to “TYPE2: Special specification” in the system mode:
[Transfer code for MaxiCode]
0 1 2 3 4 5 6 7 8 9 A B C D E F
0 NUL DLE SP 0 @ P ` p
1 SOH DC1 ! 1 A Q a q
2 STX DC2 ” 2BRbr
3 ETX DC3 # 3CScs
4 EOT DC4 $ 4DTd t
5 ENQ NAK % 5 E U e u
6 ACK SYN & 6 F V f v
7 BEL ETB ’ 7 G W g w
8 BS CAN ( 8HXhx
9 HT EM ) 9I Yi y
A
LF
(
Note1
)
SUB * : J Z j z
B VT ESC + ; K [ k {
C FF FS , < L \ l |
D CR GS - = M ] m }
E SO RS • >N^n~
F SI US / ? O _ o DEL
(Note2)
The all codes (00H to FFH) can be used. In the following cases, however, the codes will
become special codes. For the transfer method, refer to the following.
(Note 1) In case of LF (0AH) data:
LF (0AH) → J (FFH, 4AH)
(Note 2) In case of (FFH) data:
(FFH) → (FFH, FFH)
ESC (1BH) and NUL (00H) can be used as they are.